2010 Ford Explorer Owner Guide 2nd Printing (Spanish) - Page 593

Driver Controls 4. At the garage door opener receiver (motor-head unit) in the garage, locate the "learn" or "smart" button (usually near where the hanging antenna wire is attached to the unit). 5. Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.) Note: There are 30 seconds in which to initiate Step 6. 6. Return to the vehicle and firmly press, hold for two seconds and release the HomeLink௡ button. Repeat the press/hold/release sequence again and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming. HomeLink௡ should now activate your rolling code equipped device. To program additional HomeLink௡ buttons begin with Step 1 in this section. For questions or comments, please contact HomeLink at www.homelink.com or 1-800-355-3515. Gate Operator & Canadian Programming Console mount Visor mount During programming, your hand-held transmitter may automatically stop transmitting - not allowing enough time for HomeLink௡ to accept the signal from the hand-held transmitter. 137 2010 Explorer (exp) Owners Guide, 2nd Printing USA (fus)