2010 Ford Explorer Owner Guide 2nd Printing (Spanish) - Page 601

Driver Controls To erase programming on the Car2U௡ system (individual buttons cannot be erased), use the following procedure: 1. Firmly press the two outside Car2U௡ system buttons simultaneously for approximately 20 seconds until the indicator lights begin to blink rapidly. The indicator lights are located directly above the buttons. 2. Once the indicator lights begin to blink, release your fingers from the buttons. The codes for all buttons are erased. If you sell your vehicle equipped with the Car2U௡ system, it is recommended that you erase the programming for security reasons. FCC and RSS-210 Industry Canada Compliance The Car2U௡ system complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received including interference that may cause undesired operation. Changes and modifications to the Car2U௡ system transmitter by other than an authorized service facility could void authorization to use the equipment. CARGO COVER (IF EQUIPPED) Your vehicle may be equipped with a cargo area cover that covers the luggage compartment of your vehicle. To install the cover: Press both ends of the cover into the depressions (right side first) in the trim panels behind the second row seat. WARNING: To reduce the risk of injuries, the cargo area cover must be properly installed on the rear trim panels. 145 2010 Explorer (exp) Owners Guide, 2nd Printing USA (fus)