2010 Infiniti EX35 Owner's Manual - Page 162

4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2) fully for at least 1 second. The indicator light for the pushed memory switch will stay on for approximately 5 seconds after pushing the switch. If memory is stored in the same memory switch, the previous memory will be deleted. Confirming memory storage ● Push the ignition switch to the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 second. When the memory has stored in position, the indicator light will stay on for approximately 5 seconds. ● If the battery cable is disconnected, or if the fuse opens, the memory will be canceled. In this case, reset the desired position using the previous procedure. ● If optional Intelligent Keys are added to your vehicle, the memory storage procedure to switch 1 or 2 and linking Intelligent Key procedure to a stored memory position should be performed again for each Intelligent Key. For additional Intelligent Key information, see "KEYS" earlier in this section. ● Within 45 seconds of opening the driver's door, push the memory switch (1 or 2) fully for at least 1 second. The driver's seat, steering column and outside mirrors will move to the memorized position or to the exit position when the entry/exit function is set to active with the indicator light flashing, and then the light will stay on for approximately 5 seconds. Linking Intelligent Key to a stored memory position The Intelligent Key can be linked to a stored memory position with the following procedure. 1. Follow the steps for storing a memory position. 2. While the indicator light for the memory switch being set is illuminated for 5 secbutton on onds, push the UNLOCK the Intelligent Key. If the indicator light blinks, the Intelligent Key is linked to that memory setting. Push the ignition switch to the OFF position, button on the and then push the UNLOCK Intelligent Key. The driver's seat, steering wheel and outside mirrors will move to the memorized position or to the exit position when the entry/exit function is set to active. SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: ● When the vehicle speed is above 4 MPH (7 km/h). ● When the adjusting switch for the driver's seat and steering column is turned on while the automatic drive positioner is operating. ● When the memory switch 1 or 2 is not pushed for at least 1 second. ● When the seat, steering column and outside mirrors have already been moved to the memorized position. ● When no position is stored in the memory switch. Selecting the memorized position 1. Move the selector lever to the P (Park) position. 2. Use one of the following methods to move the driver's seat, the outside mirrors and the steering wheel. ● Push the ignition switch to the ON position and push the memory switch (1 or 2) fully for at least 1 second. Pre-driving checks and adjustments 3-27