2010 Infiniti EX35 Owner's Manual - Page 51

9. Check that the retractor is in the ALR mode by trying to pull more seat belt out of the retractor. If you cannot pull any more belt webbing out of the retractor, the retractor is in the ALR mode. 10. Check to make sure the child restraint is properly secured prior to each use. If the seat belt is not locked, repeat steps 3 through 9. SSS0641 SSS0676 Front-facing - step 8 8. After attaching the child restraint, test it before you place the child in it. Push it from side to side while holding the seat by the seat belt path. The child restraint should not move more than 1 inch (25 mm) from side to side. Try to tug it forward and check to see if the belt holds the restraint in place. If the restraint is not secure, tighten the belt as necessary, or put the restraint in another seat and test it again. You may need to try a different child restraint. Not all child restraints fit in all types of vehicles. Front-facing - step 11 11. If the child restraint is installed in the front passenger seat, push the ignition switch to the ON position. The front passhould senger air bag status light illuminate. If this light is not illuminated, see "Front passenger air bag and status light" later in this section. Move the child restraint to another seating position . Have the system checked by an INFINITI retailer. After the child restraint is removed and the seat belt is fully retracted, the ALR mode (child restraint mode) is canceled. 1-32 Safety - Seats, seat belts and supplemental restraint system