2010 Infiniti QX56 Owner's Manual - Page 175

2. While the indicator light for the memory switch being set is illuminated for 5 secbutton on the keyfob. onds, press the The indicator light will blink. After the indicator light goes off, the keyfob is linked to that memory setting. When the ignition switch is moved back to the button on the keyOFF position, press the fob. The driver's seat, steering wheel, accelerator and brake pedals, and outside mirrors will move to the memorized position. NOTE: If a new memory position is saved to the memory switch, the keyfob automatically re-links. ● If the battery cable is disconnected, or if the fuse opens, the memory storage function will be canceled and must be restarted before a stored memory position can be set again. Drive the vehicle over 25 MPH (40 km/h) to restart the memory storage function. You can also restart the memory storage function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than 2 times with the ignition switch in the LOCK position. Once the memory storage function has been restarted, you can store a memory position. See "Memory storage function" earlier in this section. memorized position with the indicator light blinking, and then the light will stay on for approximately 5 seconds. ENTRY/EXIT FUNCTION This system is designed so that the driver's seat and steering wheel will automatically move when the shift selector is placed in the P (Park) position. This allows the driver to get into and out of the driver's seat more easily. The driver's seat and steering wheel will slide backward: ● When the driver's door is opened with the ignition switch placed in the LOCK position. ● When the ignition switch is turned from ACC to LOCK with the driver's door open. The driver's seat and steering wheel will return to the previous position: ● When the driver's door is closed with the ignition switch placed in the LOCK position. ● When the ignition switch is turned from ACC to ON while the shift selector is in the P (Park) position. The entry/exit function can be adjusted or canceled. See "Comfort & convenience settings" in the "Monitor, climate, audio, phone and voice recognition systems" section of this manual. Confirming memory storage ● Place the ignition switch in the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored the position, the indicator light will stay on for approximately 5 seconds. Selecting the memorized position Set the shift selector to the P (Park) position, then: ● Within 45 seconds of opening the driver's door, push the memory switch (1 or 2) or ● Turn the ignition switch to the ON position and push the memory switch (1 or 2). The driver's seat, steering wheel, accelerator and brake pedals, and outside mirrors will move to the 3-30 Pre-driving checks and adjustments