2010 Jeep Compass Owner Manual - Page 194
2010 Jeep Compass Manual
Page 194 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 193 reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and release the Trip Odometer button on the instrument cluster. To reset the oil change indicator system (after performing the schedA loose, improperly installed, or damaged fuel filler cap uled maintenance), refer to the following procedure: may also turn on the Malfunction Indicator Light (MIL). 1. Turn the ignition switch to the ON position (do not Lo tIrE start the engine). When tire pressure is low, the odometer display will 2. Fully depress the accelerator pedal, slowly, three toggle between Lo and tIrE for three cycles. times within 10 seconds. CHAngE OIL Message Your vehicle is equipped with an engine oil change 3. Turn the ignition switch to the OFF/LOCK position. indicator system. The "CHAngE OIL" message will flash NOTE: If the indicator message illuminates when you in the instrument cluster odometer for approximately start the engine, the oil change indicator system did not 12 seconds after a single chime has sounded to indicate reset. If necessary repeat this procedure. the next scheduled oil change interval. The engine oil change indicator system is duty-cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. Unless area. Tighten the fuel filler cap properly and press the TRIP ODOMETER button to turn off the message. If the problem continues, the message will appear the next time the vehicle is started. 4