2010 Jeep Compass Owner Manual - Page 403
2010 Jeep Compass Manual
Page 403 highlights
402 MAINTAINING YOUR VEHICLE Fluid Level Check Check the fluid level by removing the fill plug. The fluid level should be between the bottom of the fill hole and a point not more than 3/16 in (4.7 mm) below the bottom of the hole. Add fluid, if necessary, to maintain the proper level. Frequency Of Fluid Change Under normal operating conditions, the fluid installed at the factory will give satisfactory lubrication for the life of the vehicle. Fluid changes are not necessary unless lubricant has become contaminated with water. Rear Drive Assembly (RDA) - AWD/4WD Models Only Lubricant Selection Use only the manufacturer's recommended fluid. Refer to "Fluids, Lubricants, and Genuine Parts" in "Maintaining Your Vehicle" for further information. Fluid Level Check Visually inspect the unit at each oil change for leakage. If leakage is detected, check the fluid level by removing the fill plug. The fluid level should be maintained between the bottom of the fill hole to 1/8 in (4 mm) below the fill hole. NOTE: If contaminated with water, the fluid should be changed immediately. Add fluid, if necessary, to maintain the proper level. Frequency Of Fluid Change Refer to "Maintenance Schedule" for further information.