2006 Lexus GS 300 Owners Manual - Page 1
2006 Lexus GS 300 Manual
Page 1 highlights
GAS STATION INFORMATION D Fuel selection: Select premium unleaded gasoline with an Octane Rating of 91 (Research Octane Number 96) or higher for optimum engine performance. However, if such premium type cannot be obtained, you may temporarily use unleaded gasoline with an Octane Rating as low as 87 (Research Octane Number 91). D Fuel tank capacity: 71 L (18.7 gal., 15.6 lmp.gal.) D Engine oil: "Toyota Genuine Motor Oil" or equivalent Oil grade: API grade SL "Energy−Conserving" or ILSAC multigrade engine oil. Recommend oil viscosity − SAE 5W − 30 if normal temperatures are below 38_C (100_F) Oil capacity: L (qt., lmp.qt.) Drain and refill with filter without filter GS430 5.1 (5.4, 4.5) 4.5 (4.8, 4.0) GS300 (2WD) 6.3 (6.6, 5.5) 5.9 (6.2, 5.1) GS300 (4WD) 6.4 (6.7, 5.6) 6.0 (6.3, 5.2) See page 522 for detailed information. D Engine coolant: Capacity: GS430 − 10.1 L (10.7 qt., 8.9 lmp.qt.) GS300 − 9.1 L (9.6 qt., 8.0 lmp.qt.) Coolant type − "Toyota Super Long Life Coolant" or similar high quality ethylene glycol based non−silicate, non−amine, non−nitrite, and non−borate coolant with long−life hybrid organic acid technology (Coolant with long−life hybrid organic acid technology is a combination of low phosphates and organic acids.) Do not use plain water alone. For checking the engine coolant, see page 527. D Automatic transmission: Fluid type − "Toyota Genuine ATF WS" See page 532 or 535 for detailed information. D Tire information: See page 539 through 561 for detailed information. D Tire inflation pressure: Tire size: GS430 − 245/40R18 93Y or P245/40R18 93V GS300 − 225/50R17 94W or P225/50R17 93V Tire inflation pressure: Front 230 kPa (2.3 kgf/cm2 or bar, 33 psi) Rear 230 kPa (2.3 kgf/cm2 or bar, 33 psi) For sustained high speeds above 160 km/h (100 mph), in countries where such speeds are permitted by law, add the tire inflation pressure given below to the front tires and rear tires, but never exceed the maximum cold tire inflation pressure molded on the tire sidewall. GS430 GS300 60 kPa (0.6 kgf/cm2 or bar, 9 psi) 50 kPa (0.5 kgf/cm2 or bar, 7 psi)