2006 Lexus GS 300 Owners Manual - Page 373

STARTING AND DRIVING How to start the engine Before starting the engine, be sure to follow the instructions. CRANKING HOLD FUNCTION Once you push the engine switch while the brake pedal is depressed, the cranking hold function continues to crank the engine in "IG−ON" mode until it starts. The function stops cranking the engine after about 25 seconds at maximum if the engine has not started yet. When you crank the engine again, wait a few seconds and restart it. BEFORE STARTING THE ENGINE 1. Check the area around the vehicle before entering it. 2. Adjust seat position, seatback angle, seat cushion angle, seat cushion height, head restraint height and steering wheel angle. 3. Adjust the inside and outside rear view mirrors. 4. Lock all doors. 5. Fasten seat belts. Remember to check that the service reminder indicators function when the engine switch is selected in "IG−ON" mode, and check the fuel gauge to see that you have sufficient fuel. BEFORE CRANKING 1. Apply the parking brake firmly. 2. Turn off unnecessary lights and accessories. 3. Put the selector lever in "P". If you need to restart the engine while the vehicle is moving, put the selector lever in "N". A starter safety device will prevent the starter from operating if the selector lever is in any drive position. 4. Depress the brake pedal and hold it to the floor until driving off. The multiport fuel injection system/sequential multiport fuel injection system in your engine automatically controls the proper air−fuel mixture for starting. You can start a cold or hot engine as follows: 349