2006 Lexus GS 300 Owners Manual - Page 463

STARTING AND DRIVING D Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. D Consult the dealer or an experienced radio / TV technician for help. FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. For vehicles sold in Canada Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Replacing tires and wheels As you might have difficulty in locating a flat or deflated tire, a tire pressure warning system should be installed on the tires of this vehicle. When replacing the wheels, be sure to install tire pressure sensors on the wheels. There are 3 ways to set up the tire pressure sensors: a. Remove the sensor from the old wheel and install it to the new wheel. b. Keep the same wheel with tire pressure sensor and replace the tire alone. c. Use a new wheel and sensor. You have to register an ID code for a new sensor. Up to 2 sets of codes can be registered. As one ID for the originally installed sensor is registered at "MAIN" of the selector switch, use the "2nd" position to register an ID for the new sensor. You do not need to re−register the ID code for any other replacements. For the use of the originally installed tires, put the selector switch at "MAIN" and for the use of tires set purchased later, put the switch at "2nd". For the sensor selector switch, see page 442. 439