2002 Mazda Millenia Owner's Manual - Page 183

J76Y.book Page 11 Wednesday, March 27, 2002 5:04 PM Maintenance and Care Owner Maintenance 5. Pull it out again and examine the level. It's OK between L and F. But if it's near at or below L, add enough oil to bring the level to F. Changing engine oil WARNING Checking or Changing Engine Oil: Hot engine oil is dangerous. If the engine has been running, the engine oil becomes very hot. You could be seriously burned. Don't check or change the engine oil when the engine is hot. 2.5 liter V6 DOHC CAUTION Don't add engine oil over F. This may cause engine damage. 6. Make sure the O-ring is positioned properly before reinserting the dipstick. The distance between L and F on the dipstick represents the following: Loosen L (US qt, Imp qt) 0.9 (1.0, 0.8) Tighten M Changing Engine Oil and Filter Change engine oil and filter according to Scheduled Maintenance (page 8-3). Drain plug Please act responsibly-protect the environment and take used oil to a recycling facility. Ask your dealer or a service station for information. Miller Cycle Engine V6 DOHC WARNING Handling Used Engine Oil: Continuous contact with used engine oil is dangerous. It could cause skin cancer. Always wash with soap and water immediately after changing oil and filter. Loosen Tighten Drain plug 1. Warm up the engine for a few minutes and turn it off. Remove the oil-filler cap. 2. Remove the drain plug and drain the oil into a suitable container. 8-11 Form No. 8Q47-EA-01F