2011 Mercedes SLK-Class Owner's Manual - Page 196
2011 Mercedes SLK-Class Manual
Page 196 highlights
171_AKB; 3; 60, en-US d2ureepe, 2009-05-11T16:00:23+02:00 - Seite 194 Version: 2.11.8.1 194 X Engine compartment Slowly insert oil dipstick : fully into the dipstick guide tube. X Pull out oil dipstick : again after approximately 3 seconds to obtain accurate reading. The oil level is correct when it is between lower (min) mark = and upper (max) mark ; of oil dipstick :. OK RAdd RAdd RAdd 1.0 qt. (Canada: 1.0 liter) to reach max. oil level. 1.5 qts. (Canada: 1.5 liters) to reach max. oil level. 2.0 qts. (Canada: 2.0 liters) to reach max. oil level. Operation i The filling quantity between the upper and lower marks on the oil dipstick is approximately 2.1 US qt. (2.0 l). X i If you want to interrupt the checking procedure, press button * or & on the multifunction steering wheel. X If necessary, add engine oil. For more information on engine oil, see "Fuels, coolants, lubricants etc." (Y page 300). For information on messages in the multifunction display concerning engine oil, see the "Practical hints" section (Y page 250). If necessary, add engine oil. For more information on engine oil, see "Fuels, coolants, lubricants etc." (Y page 300). Other display messages If the ignition is not switched on, the following message appears in the multifunction display: Turn on ignition to see engine oil level. X Switch on the ignition. If you see the message: Observe Waiting Time X If the engine is at operating temperature, wait 5 minutes before repeating check procedure. X If the engine is not at operating temperature yet, you must wait 30 minutes before checking oil. If you see the message: Cannot check engine oil level with engine on. X Turn off the engine. X If the engine is at operating temperature, wait 5 minutes before checking oil. X If the engine is not at operating temperature yet, you must wait 30 minutes before checking oil. Checking engine oil level with the control system On the SLK 55 AMG you can check the engine oil level with the control system. X Switch on the ignition. The standard display appears in the multifunction display (Y page 96). X Press button * or & on the multifunction steering wheel repeatedly until the following message appears in the multifunction display: One of the following messages will subsequently appear in the multifunction display: REngine Oil Level