2011 Mercedes SLK-Class Owner's Manual - Page 279

171_AKB; 3; 60, en-US d2ureepe, 2009-05-11T16:00:23+02:00 - Seite 277 Version: 2.11.8.1 Flat tire Mounting the spare wheel Introduction X 277 Prepare the vehicle as described (Y page 273). X Take the following out of the vehicle: Rspare wheel Rjack Rwheel wrench wheel chock bolts for spare wheel bolt air pump Rcollapsible Rwheel Ralignment Relectric For information on where to find the respective items, see "Where will I find ...?" (Y page 234) and (Y page 235). i Vehicles without spare wheel are not factory-equipped with the tools required for a wheel change such as a jack or a wheel wrench. Some tools required for a wheel change are specific to your vehicle. Contact an authorized Mercedes-Benz Center to obtain the tools approved for your vehicle. This section describes the wheel change using the tools approved and recommended for your vehicle. Lifting the vehicle G Warning! When jacking up the vehicle, only use the jack which has been specifically approved by Mercedes-Benz for your vehicle. The jack is designed exclusively for jacking up the vehicle at the jack take-up brackets built into both sides of the vehicle. Make sure the jack arm is fully seated in the jack take-up bracket. The jack must always be vertical when in use, especially on inclines or declines. The jack is intended only for lifting the vehicle briefly for wheel changes. It is not suited for performing maintenance work under the vehicle. To help avoid personal injury, use the jack only to lift the vehicle during a wheel change. Never get beneath the vehicle while it is supported by the jack. Keep hands and feet away from the area under the lifted vehicle. Always lower the vehicle onto sufficient capacity jackstands before working under the vehicle. Always engage the parking brake firmly and block the wheels with wheel chocks or other sizeable objects before raising the vehicle with the jack. Do not disengage the parking brake while the vehicle is raised. Make sure that the ground on which the vehicle is standing and where you place the jack is solid, level and not slippery. If necessary, use a large underlay. On slippery surfaces, such as tiled floors, you should use a non-slip underlay, for example a rubber mat. Do not use wooden blocks or similar objects to support the jack. Otherwise the jack may not be able to achieve its load-bearing capacity if it is not at its full height. Never start the engine when the vehicle is raised. Also observe the notes on the jack. X Prevent the vehicle from rolling away by blocking wheels with wheel chocks or other sizeable objects. When your vehicle is equipped with a wheel chock, it is included with the vehicle tool kit (Y page 234). For information on setting up the collapsible wheel chock, see (Y page 234). Place a wheel chock or other sizeable object in front of and another wheel chock or other sizeable object behind the wheel that is diagonally opposite to the wheel being changed. When changing a wheel on a level surface: X Z Practical hints