2011 Mercedes SLK-Class Owner's Manual - Page 80

171_AKB; 3; 60, en-US d2ureepe, 2009-05-11T16:00:23+02:00 - Seite 78 Version: 2.11.8.1 78 Power windows If the windshield wipers fail to function at all with the combination switch in position I, Rset holding button & on the SmartKey the automatic reversal function will not operate. the combination switch to the next higher wiper speed the windshield wipers checked at the nearest authorized Mercedes-Benz Center Rhave i You can also open or close the windows using the SmartKey, see "Summer opening feature" (Y page 172) and "Convenience closing feature" (Y page 172). i After switching off the ignition or removing the SmartKey from the starter switch, you can operate the windows until you open a door. If no door was opened you can operate the windows for up to 5 minutes. Controls in detail Power windows Opening and closing The windows are opened and closed electrically. The switches for all windows are located on the driver's door. The switch for operating the passenger-side windows is located on the passenger door. G Observe Safety notes, see page 45. G Warning! When closing the windows, make sure there is no danger of anyone being harmed by the closing procedure. The door windows are equipped with the express operation and automatic reversal function. If in express operation mode a door window encounters an obstruction that blocks its path, the automatic reversal function will stop the door window and open it slightly. The door windows operate differently when the switch is pulled and held. See the "Closing when a door window is blocked" section for details. The closing of the door windows can be immediately halted by releasing the switch or, if the switch was pulled past the resistance point and released, by pressing or pulling the respective switch. The closing of the rear side windows can be immediately halted by releasing the switch. If a window encounters an obstruction that blocks its path in a circumstance where you are closing the windows by pressing and Door windows X X Switch on the ignition. Opening/closing: Press or pull and hold switch : or ; to the resistance point. The corresponding door window moves downward or upward until you release the switch. X Express operation: Press or pull switch : or ; past the resistance point and release. The corresponding door window opens or closes completely. X Stopping during express operation: Press or pull the respective switch again.