2012 Nissan cube Owner's Manual - Page 286
2012 Nissan cube Manual
Page 286 highlights
the casing. 3. Replace the battery with a new one. Recommended battery: CR1620 or equivalent Do not touch the internal circuit and electric terminals as doing so could cause a malfunction. . Hold the battery by the edges. Holding the battery across the contact points will seriously deplete the storage capacity. . Make sure that the + side faces the bottom of the case. . NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. For Canada: This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. 4. Close the lid securely and install the screw. 5. Operate the buttons to check its operation. See a NISSAN dealer if you need any assistance for replacement. FCC Notice: For USA: SDI2134 KEYFOB Replace the battery in the keyfob as follows: 1. Remove the screw. 2. Insert a small screwdriver into the slit of the corner and twist it to separate the upper part from the lower part. Use a cloth to protect This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 8-24 Maintenance and do-it-yourself