2012 Nissan cube Owner's Manual - Page 31

suitable tool (such as a knife or scissors) to release the seat belt. Fastening the seat belts 1. Adjust the seat. (See "Seats" (P.1-2).) 2. Make sure rear seat belt buckles are removed from the stowed position. See "Rear seat belt buckles (except for Cargo Van models)" (P.1-14). SSS0292 SSS0290 3. Slowly pull the seat belt out of the retractor and insert the tongue into the buckle until you hear and feel the latch engage. . The retractor is designed to lock during a sudden stop or on impact. A slow pulling motion permits the belt to move and allows you some freedom of movement in the seat. . If the seat belt cannot be pulled from its fully retracted position, firmly pull the belt and release it. Then smoothly pull the belt out of the retractor. 4. Position the lap belt portion low and snug on the hips as shown. 5. Pull the shoulder belt portion toward the retractor to take up extra slack. Be sure the shoulder belt is routed over your shoulder and across your chest. The front passenger seat and the rear seating positions three-point seat belts have two modes of operation: . Emergency Locking Retractor (ELR) . Automatic Locking Retractor (ALR) The Emergency Locking Retractor (ELR) mode allows the seat belt to extend and retract to allow the driver and passengers some freedom Safety - Seats, seat belts and supplemental restraint system 1-13