2012 Nissan cube Owner's Manual - Page 36

To connect the buckle: 1. Remove the seat belt tongue and connector 1 . tongue from the seat belt hook * 2. Pull the seat belt and secure the connector 2 . buckle until it clicks * The rear center seat belt connector tongue can be attached only into the rear center seat belt connector buckle. To fasten the seat belt, see "Fastening the seat belts" (P.1-13). SEAT BELT EXTENDERS If, because of body size or driving position, it is not possible to properly fit the lap-shoulder belt and fasten it, an extender that is compatible with the installed seat belts is available that can be purchased. The extender adds approximately 8 in (200 mm) of length and may be used for either the driver or front passenger seating position. See a NISSAN dealer for assistance with purchasing an extender if an extender is required. WARNING . When attaching the rear center seat belt connector, be certain that the seatbacks are completely secured in the latched position and the rear center seat belt connector is completely secured. If the rear center seat belt connector and the seatbacks are not secured in the correct position, serious personal injury may result in an accident or sudden stop. . WARNING Only NISSAN seat belt extenders, made by the same company which made the original equipment seat belts, should be used with NISSAN seat belts. Adults and children who can use the standard seat belt should not use an extender. Such unnecessary use could result in serious personal injury in the event of an accident. Never use seat belt extenders to install child restraints. If the child restraint is not secured properly, the child could be seriously injured in a SSS0966 . . Attaching rear center seat belt: Always be sure the rear center seat belt connector tongue and connector buckle are attached. Disconnect only when folding down the rear seat. . 1-18 Safety - Seats, seat belts and supplemental restraint system