2013 Nissan Juke Owner's Manual - Page 104

Battery saverGUID-E8409034-D45E-48DE-A071-E3A41898289B system . When the headlight switch is in the or position while the ignition switch is in the ON position, the lights will automatically turn off within a period of time after the ignition switch has been placed in the OFF position. When the headlight switch remains in the or position after the lights automatically turn off, the lights will turn on when the ignition switch is placed in the ON position. . SAA1232 SIC3670 Be sure not to put anything on top of the 1 located on the top of the photo sensor * instrument panel. The photo sensor controls the autolight; if it is covered, the photo sensor reacts as if it is dark and the headlights will illuminate. Headlight beam select GUID-65D36B20-DAE3-4840-AD10-0068CB054884 1 * 2 * CAUTION . When you turn on the headlight switch again after the lights automatically turn off, the lights will not turn off automatically. Be sure to turn the light switch to the OFF position when you leave the vehicle for extended periods of time, otherwise the battery will be discharged. Never leave the light switch on when the engine is not running for extended periods of time even if the headlights turn off automatically. Automatic headlights off delay GUID-CFAAEF09-71A1-4057-9F7B-96D46980C786 You can keep the headlights on for up to 45 seconds after you place the ignition switch in OFF and open any door then close all the doors. 3 * To select the low beam, put the lever in the neutral position as shown. To select the high beam, push the lever forward while the switch is in the position. Pull it back to select the low beam. Pulling the lever toward you will flash the headlight high beam even when the headlight switch is in the OFF position. . 2-36 Instruments and controls