2013 Nissan Juke Owner's Manual - Page 178

Audio main GUID-B7DABF3E-5C88-4BBA-86D6-737C31A851CA operation Head unit: GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 The auto loudness circuit enhances the low and high frequency ranges automatically in both radio reception and CD playback. ON·OFF/Volume control: GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Place the ignition switch in the ACC or ON position, and then push the PWR button while the system is off to call up the normal mode (radio, CD, AUX and iPod®) which was playing immediately before the system was turned off. While the system is on, pushing the PWR button turns the system off. Turn the VOL control knob to adjust the volume. MUTE button: GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Push the button to mute the audio sound. Push the setting. button again to release the mute level. Use the TUNE or SEEK button also to adjust Fade or Balance modes. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To turn the beep sound off or on, push the TUNE or SEEK button until the desired mode is displayed. This turns on or off the beep sound when audio buttons are pushed. To change the Speed Sensitive Volume (Spd Sen Vol) mode to OFF, LOW, MID or HIGH, push the TUNE or SEEK button until the desired mode is displayed. Once you have adjusted the sound quality to the desired level, push the AUDIO button repeatedly until the normal mode display reappears. Otherwise, the normal mode display will automatically reappear after approximately 5 seconds. CLOCK button: GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Push the CLOCK button to turn on or off the CLOCK display. See "Clock" (P.2-40) for the detailed clock adjustment operation. SAA3490 Radio operation GUID-22EF80F5-05BF-4F5B-A66D-F3494E16E043 Radio (FM/AM) band select: GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Pushing the FM·AM radio band select button will change the band as follows: AM ? FM1 ? FM2 ? AM When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. When the radio band select button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. AUDIO button: GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Push the AUDIO button to change the selecting mode as follows. NOS2545 Push the TUNE ( , ) or SEEK ( , ) button to adjust Bass and Treble to the desired 4-32 Heater, air conditioner, audio and phone systems