2013 Nissan Juke Owner's Manual - Page 227

WARNING Apply the parking brake if the selector lever is in any position while the engine is not running. Failure to do so could cause the vehicle to move unexpectedly or roll away and result in serious personal injury or property damage. If the ignition switch is placed in the OFF or ACC position for any reason while the selector lever is in any positions other than the P (Park), the ignition switch cannot be placed in the LOCK position. If the ignition switch cannot be placed in the LOCK position, perform the following steps: 1. Apply the parking brake when the vehicle is stopped. 2. Place the ignition switch in the ON position while depressing the foot brake pedal. 3. Move the selector lever to the P (Park) position. 4. Models with Intelligent Key system: Place the ignition switch in the OFF position. Models without Intelligent Key system: Place the ignition switch in the LOCK position. CAUTION To prevent transmission damage, move the selector lever to the P (Park) or R (Reverse) position only when the vehicle is completely stopped. P (Park): GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Use this selector position when the vehicle is parked or when starting the engine. Make sure the vehicle is completely stopped. The brake pedal must be depressed and the selector lever button pushed in to move the selector lever from N (Neutral) or any drive position to P (Park). Apply the parking brake. When parking on a hill, apply the parking brake first, then move the selector lever to the P (Park) position. R (Reverse): GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Use this position to back up. Make sure the vehicle is completely stopped before selecting the R (Reverse) position. The brake pedal must be depressed and the selector lever button pushed in to move the selector lever from P (Park), N (Neutral) or any driving position to R (Reverse). N (Neutral): GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Neither forward nor reverse gear is engaged. The engine can be started in this position. You may shift to N (Neutral) and restart a stalled engine while the vehicle is moving. D (Drive): GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Use this position for all normal forward driving. Manual shift GUID-D712A263-68AD-455F-8166-C902EBCAB071 mode (if so equipped) When the selector lever is shifted from the D position to the manual shift gate, the transmission enters the manual shift mode. Shift ranges can be selected manually. In the manual shift mode, the shift range is displayed on the position indicator in the meter. Shift ranges up or down one by one as follows: M1 ? / M2 ? / M3 ? / M4 ? / M5 ? / M6 . . . When shifting up, move the selector lever to the + (up) side. The transmission shifts to a higher range. When shifting down, move the selector lever to the − (down) side. The transmission shifts to a lower range. Moving the selector lever to the same side twice will shift the ranges in succession. However, if this motion is rapidly done, the second shifting may not be completed Starting and driving 5-19