2013 Nissan Juke Owner's Manual - Page 179

Radio (SAT) band select: GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Pushing the button will change the band as follows: AUX (if connected portable device) ? XM1* ? XM2* ? XM3* ? AUX (if connected portable device) The last channel played will also come on when the ON·OFF button is pushed to ON. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. When the radio band select button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. *: if so equipped TUNE (Tuning): GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 For AM and FM radio or for Push the TUNE button manual tuning. To move quickly through the stations, push and hold the TUNE button. For SiriusXM Satellite Radio* or to seek Push the TUNE button stations from all of the categories when any CAT is not selected. *: if so equipped SEEK tuning CATEGORY: GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 . For AM and FM radio Push the SEEK button or to tune from low to high or high to low frequencies and to stop at the next broadcasting station. . For SiriusXM Satellite Radio* Push the or to tune to the first station of the next or previous category. *: if so equipped During satellite radio reception, the following notices will be displayed under certain conditions...NO SIGNAL (No signal is received while the SAT tuner is connected.) OFF AIR (Broadcasting signed off) CHECK ANTENNA (Antenna connection error) LOADING (When the initial setting is performed) UPDATING (When the satellite radio subscription is not active) INVALID CH (Invalid channel is received.) during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station. to Station memory operations: GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 12 stations can be set for the FM band (6 each for FM1 and FM2), 18 for SiriusXM Satellite Radio (6 each for XM1, XM2 and XM3)* and 6 can be set for the AM band for easy access. 1. Choose the radio band using the radio band select button. 2. Tune to the desired station using the SEEK, SCAN or TUNE button. 3. Push and hold the desired radio station preset button to until a beep sound is heard. (The radio mutes when the radio station preset button is pushed.) 4. The station indicator will then come on and the sound will resume. Memorizing is now complete. 5. Other buttons can be set in the same manner. If the battery cable is disconnected, or if the fuse opens, the radio memory will be erased. In that case, reset the desired stations. . . SCAN tuning: GUID-3448E018-0BC4-4D17-AD0E-3BB850F23C53 Push the SCAN button to tune from low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the button again Heater, air conditioner, audio and phone systems 4-33