2015 Nissan Juke Owner's Manual - Page 108

The windshield wiper and washer operates when the ignition switch is in the ON position. Push the lever down to operate the wiper at the following speed: 1 * 2 * 3 * To move the wiper blades back to the original position: . 4 or push the lever down Lift the lever up * to operate at any wiper speed. Intermittent - intermittent operation can be adjusted by turning the knob toward A (Slower) or B (Faster). Low - continuous low speed operation High - continuous high speed operation * * . CAUTION This function can be operated even if the ignition switch is in the "ON" position. However, to prevent an accident or damage when pulling up the wiper arm, be sure to observe the following precautions. - Make sure the shift lever is in the P (Park) position (Continuously Variable Transmission models). - Make sure the shift lever is in the N (Neutral) position, with the parking brake fully applied (Manual Transmission models). - Never allow the passengers to operate the windshield wiper switch inadvertently. . Do not operate the windshield wiper while the wiper arm is pulled up. The wiper arm may be damaged. Instruments and controls 2-33 4 Push the lever up * to have one sweep operation of the wiper. 5 Pull the lever toward you * to operate the washer. Then the wiper will also operate several times. SIC3664 Type A (if so equipped) Pulling up the wiper arm: The windshield wipers must be in the service position in order to replace the wiper blades. To move the wiper blades to the service position, follow this procedure: . When the ignition switch is in the "ON" position or within 60 seconds of placing the ignition switch to the "OFF" position, lift the 4 lever up * two times in less than 0.5 seconds. The windshield wipers will move to the service position automatically, and the wiper blades can now be replaced. To replace the wiper blades, see "Windshield wiper blades" (P.8-18). JVI1010X Type B (if so equipped)