2015 Nissan Juke Owner's Manual - Page 319

Waste oil must be disposed of properly. . Check your local regulations. (Perform steps 4 to 7 only when the engine oil filter change is needed.) 4. Loosen the oil filter with an oil filter wrench. Remove the oil filter by turning it by hand. 5. Wipe the engine oil filter mounting surface with a clean rag. . Drain plug tightening torque: 22 to 29 ft-lb (29 to 39 N·m) Do not use excessive force. 9. Refill the engine with the recommended oil through the oil filler opening, and install the oil filler cap securely. See "Capacities and recommended fluids/ lubricants" (P.9-2) for drain and refill capacity. The drain and refill capacity depends on the oil temperature and drain time. Use these specifications for reference only. Always use the dipstick to determine the proper amount of oil in the engine. 10. Start the engine and check for leakage around the drain plug and the oil filter. Correct as required. 11. Turn the engine off and wait more than 10 minutes. Check the oil level with the dipstick. Add engine oil if necessary. CAUTION SDI2651 1. 2. 3. Oil filler cap Oil drain plug Oil filter Be sure to remove any old gasket material remaining on the mounting surface of the engine. Failure to do so could lead to engine damage. 6. Coat the gasket on the new filter with clean engine oil. 7. Screw in the oil filter clockwise until a slight resistance is felt, then tighten additionally more than 2/3 turn. Oil filter tightening torque: 11 to 15 ft-lb (14.7 to 20.5 N·m) 8. Clean and re-install the drain plug with a new washer. Securely tighten the drain plug with a wrench. Engine oil and filter 1. Place a large drain pan under the drain plug. 2. Remove the oil filler cap. 3. Remove the drain plug with a wrench and completely drain the oil. After the operation 1. Lower the vehicle carefully to the ground. 2. Dispose of waste oil and filter properly. CAUTION Be careful not to burn yourself, as the engine oil is hot. 8-10 Maintenance and do-it-yourself