2015 Nissan Juke Owner's Manual - Page 227
2015 Nissan Juke Manual
Page 227 highlights
quit the voice recognition system at any time. Microphone: Microphone is located near the map lights. Manual control: While using the Voice Recognition system, it is possible to select menu options by using the steering wheel controls instead of speaking voice commands. To activate manual control mode, push the button on the steering wheel to access the phone menu and then tilt the tuning switch ( or ) up or down. SAA3385 Changing voice feedback volume If you want to adjust the volume of the voice feedback, push the volume control switch on the steering wheel while being provided with feedback. You can also use the VOL (volume) control knob on the audio unit. Initialization When the ignition switch is placed in the ACC or ON position, voice recognition is initialized, which takes a few seconds. If the button is pushed before the initialization completes, the system will announce "Hands-free phone system not ready" and will not react to voice commands. Connecting procedure: NOTE: The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled. You can register up to 5 different Bluetooth cellular phones in the in-vehicle phone module. However, you can talk on only one cellular phone at a time. To connect a phone to the Bluetooth HandsFree Phone System; Control buttons and microphone The control buttons for the Bluetooth HandsFree Phone System are located on the steering wheel. PHONE SEND: button to initiate a VR session or Push the answer an incoming call. You can also use the button to interrupt the system feedback and give a command at once. See "List of voice commands" and "During a call" in this section for more information. PHONE END: While the voice recognition system is active, push and hold the button for 5 seconds to The manual control mode does not allow dialing a phone number by digits. The user may select an entry from the Phonebook or Recent Calls lists. To reactivate Voice Recognition, exit the manual control mode by pushing and holding the button. At that time, pushing the button will start the Hands Free Phone System. Choosing a language You can interact with the Bluetooth HandsFree Phone System using several languages that are available. For operations to change the language, see "Audio main operation" (P.4-42) or "Audio main operation" (P.4-51). 4-76 Heater, air conditioner, audio and phone systems