2015 Nissan Juke Owner's Manual - Page 292
2015 Nissan Juke Manual
Page 292 highlights
4. Lower the vehicle slowly until the tire touches the ground. Then, with the wheel nut wrench, tighten the wheel nuts securely in the sequence as illustrated. Lower the vehicle completely. tightened to specifications at each lubrication interval. . Adjust tire pressure to the COLD pressure. COLD pressure: After the vehicle has been parked for 3 hours or more or driven less than 1 mile (1.6 km). COLD tire pressures are shown on the Tire and Loading Information label affixed to the driver side center pillar. WARNING . Incorrect wheel nuts or improperly tightened wheel nuts can cause the wheel to become loose or come off. This could cause an accident. Do not use oil or grease on the wheel studs or nuts. This could cause the nuts to become loose. Retighten the wheel nuts when the vehicle has been driven for 600 miles (1,000 km) (also in cases of a flat tire, etc.). . SCE0933 . Stowing the damaged tire and the tools 1. Securely store the jack, tools and the damaged tire in the storage area. 2. Replace the cargo floor box and board. 3. Close the lift gate. Installing the spare tire The spare tire is designed for emergency use. (See specific instructions under the heading "Wheels and tires" (P.8-31).) 1. Clean any mud or dirt from the surface between the wheel and hub. 2. Carefully put the spare tire on and tighten the wheel nuts finger tight. Check that all the wheel nuts contact the wheel surface horizontally. 3. With the wheel nut wrench, tighten wheel nuts alternately and evenly in the sequence 1 ,* 2 ,* 3 ,* 4 ,* 5 ), more as illustrated (* than 2 times, until they are tight. . WARNING . Always make sure that the spare tire and jacking equipment are properly secured after use. Such items can become dangerous projectiles in an accident or sudden stop. The spare tire and small size spare tire are designed for emergency use. See specific instructions under the In case of emergency 6-7 As soon as possible, tighten the wheel nuts to the specified torque with a torque wrench. Wheel nut tightening torque: 80 ft-lb (108 N·m) The wheel nuts must be kept tightened to specifications at all times. It is recommended that the wheel nuts be .