2015 Nissan Juke Owner's Manual - Page 211

Audio settings: button. 1. push the 2. Touch the "Settings" key. 3. Touch the "Audio" key. Use the touch-screen to adjust the following items to the desired setting: . Bass: Adjusts the bass to the desired level. . Treble: Adjusts the treble to the desired level. . Balance: Adjusts the balance to the desired level. Balance adjusts the sound level between the left and right speakers. . Fade: Adjusts the fade to the desired level. Fade adjusts the sound level between the front and rear speakers. . Speed Sensitive Vol.: Adjusts the speed sensitive volume function, which increases the volume of the audio system as the speed of the vehicle increases. Set to "OFF" to disable the feature. The higher the setting, the more the volume increases in relation to vehicle speed. . AUX Volume Level: Controls the volume level of incoming sound when an auxiliary device is con- nected to the system. Available options are Low (Quiet), Medium, and High (Loud). Bass, treble, balance and fade can also be adjusted by pushing the AUDIO control knob and turning it to select the item to adjust. When the desired item is shown on the display, turn the tuning to adjust and then push the AUDIO button until the display returns to the main audio screen. If the button is not pushed for approximately 10 seconds, the radio or CD display will automatically reappear. SXM settings: To view the SXM settings: 1. Push the button. 2. Touch the "Settings" key. 3. Touch the "SXM" key. The signal strength, activation status and other information are displayed on the screen. FM/AM/SAT radio operation FM·AM button: Push the FM·AM button to change the band as follows: AM ? FM1 ? FM2 ? AM If another audio source is playing when the FM·AM button is pushed, the audio source playing will automatically be turned off and the last radio station played will begin playing. The FM stereo indicator (ST) is shown on the screen during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. SXM band select: Pushing the SXM button will change the band as follows: SXM1* ? SXM2* ? SXM3* ? SXM1* (satellite, if so equipped) When the SXM button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the last station played. The last station played will also come on when the ON·OFF button is pushed. *When the SXM button is pushed, the satellite radio mode will be skipped unless an optional satellite receiver and antenna are installed and a 4-60 Heater, air conditioner, audio and phone systems