2007 Subaru Outback Owner's Manual - Page 139
2007 Subaru Outback Manual
Page 139 highlights
3-16 Instruments and controls ABS warning light (U.S.) (Canada) The ABS warning light comes on when the ignition switch is turned to the "ON" position and goes out after approximately 2 seconds. This is an indication that the ABS system is working properly. If any of these conditions occur, have the ABS system repaired at the first available opportunity by your SUBARU dealer. The ABS warning light comes on together with the brake system warning light if the EBD system becomes faulty. For further details of the EBD system fault warning, refer to "Brake system warning light". Brake system warning light (U.S.) (Canada) If the warning light behaves as follows, the ABS system may not work properly. When the warning light is on, the ABS function shuts down; however, the conventional brake system continues to operate normally. The warning light does not come on when the ignition switch is turned to the "ON" position. The warning light comes on when the ignition switch is turned to the "ON" position, but it does not go out even when the vehicle speed exceeds approximately 8 mph (12 km/h). The warning light comes on during driving. NOTE If the warning light behavior is as described in the following, the ABS system may be considered normal. The warning light comes on right after the engine is started but goes out immediately, remaining off. The warning light remains on after the engine has been started, but it goes out when the vehicle speed reaches approximately 8 mph (12 km/h). The warning light comes on during driving, but it goes out immediately and remains off. When driving with an insufficient battery voltage such as when the engine is jump started, the ABS warning light may come on. This is due to the low battery voltage and does not indicate a malfunction. When the battery becomes fully charged, the light will go out. Driving with the brake system warning light on is dangerous. This indicates your brake system may not be working properly. If the light remains on, have the brakes inspected by a SUBARU dealer immediately. If at all in doubt about whether the brakes are operating properly, do not drive the vehicle. Have your vehicle towed to the nearest SUBARU dealer for repair. This light has the following three functions: Parking brake warning The light comes on with the parking brake applied while the ignition switch is in the "ON" position. It goes out when the parking brake is fully released. Brake fluid level warning This light comes on when the brake fluid level has dropped to near the "MIN" level of the brake fluid reservoir with the ignition switch in the "ON" position and with the