2007 Subaru Outback Owner's Manual - Page 361

11-44 Maintenance and service spring securely. 7. Reconnect the electrical connector. 8. Install the bulb cover. 9. Install the air intake duct with clip. (right-hand side) 10.Set the washer tank to the original place and secure it by clip. (left-hand side) High beam light bulbs 0 B00541 B00542 B00116 B00342 Left-hand side 2. Use a screwdriver to remove the secured clip of the washer tank. To make it easy to access the bulb, move the washer tank to the horizontal direction. (left-hand side) B00542 B00116 Right-hand side 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct. (right-hand side) 3. Disconnect the electrical connector from the bulb. 4. Remove the bulb from the headlight assembly by turning it counterclockwise. 5. Replace the bulb with new one. 6. Reconnect the electrical connector. At this time, use care not to touch the bulb surface. 7. To install the bulb to the headlight assembly, turn it clockwise until it clicks. 8. Install the air intake duct with clip. (right-hand side) 9. Set the washer tank to the original place and secure it by clip. (left-hand side)