2007 Subaru Outback Owner's Manual - Page 351

11-34 Maintenance and service Return the passenger-side wiper arm to its original position before returning the driver-side wiper arm to its original position. Otherwise, the passenger-side wiper assembly and driver-side wiper assembly will touch each other, possibly resulting in scratches. If you cannot eliminate the streaking even after following this method, replace the wiper blades using the following procedures. Be sure to use genuine SUBARU wiper blade rubbers as replacements. 2. While pressing the wiper blade stopper, slide the wiper blade assembly downward. 3. Remove the wiper blade assembly from the wiper arm. 4. Put the wiper blade assembly on the wiper arm and slide it upward while pressing the wiper blade stopper. Make sure that it locks in place. 5. Hold the wiper arm by hand and slowly lower it in position. Windshield wiper blade rubber Windshield wiper blade assembly 1. Raise the wiper arm off the windshield. Do not let go of the wiper arm until it touches the windshield. Letting the wiper arm snap onto the windshield could damage it. B00396 1) Metal support 1. Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the metal support. B00329