2007 Subaru Outback Owner's Manual - Page 155

3-32 Instruments and controls NOTE Rear window wiper and washer switch speed is low; shorter when the vehicle speed is high). When you subsequently move the selector lever of the automatic transmission to the "R" position, the rear wiper will switch to continuous operation. When you move the selector lever from the "R" position to some other position, the rear wiper will return to intermittent operation. Washer To wash the rear window while the rear wiper is operating, turn the knob on the end of the wiper control lever upward to the " " position. The washer fluid sprays until you release the knob. To wash the rear window when the rear wiper is not in use, turn the knob on the end of the wiper control lever downward to the " " position. The washer fluid sprays and the wiper operates until you release the knob. 300544 The windshield washer fluid warning light comes on when the washer fluid level in the tank has dropped to the lower limit. If the warning light illuminates, refill the tank with fluid. For the tank refilling method, refer to the "Windshield washer fluid" section in chapter 11. 300782 : Washer (accompanied by wiper operation) ON: Continuous INT: Intermittent OFF: Park : Washer Rear wiper To turn the rear wiper on, turn the knob on the end of the wiper control lever upward to the "INT" or "ON" position. To turn the wiper off, return the knob on the end of the lever to the "OFF" position. With the switch turned to the "INT" position, the rear wiper will operate intermittently at intervals corresponding to the vehicle speed (longer when the vehicle