2007 Subaru Outback Owner's Manual - Page 182
2007 Subaru Outback Manual
Page 182 highlights
5-9 road or inside of a parking garage. To help reduce this condition, satellite radio providers have installed ground-based repeaters in heavily populated areas. However, you may still experience reception problems in some areas. Band selection button Push the "SAT" button (1) when the radio is off to turn on the radio. Push the "SAT" button when the radio is on to select SAT1, SAT2 or SAT3 reception. Channel selection Press " " of the TUNE TRACK button (4) to select the next channel and press " " of the button to select the previous channel. Keep pressing " " of the button to change to the next channel continuously and keep pressing " " of the button to change to the previous channel continuously. Category selection Press " " or " " of the SEEK FLDR button (7) to display the current category. Press " " again to select the next category, and press " " again to select the previous category. Channel scan Press the "SCAN" button (8) to change the radio to the SCAN mode. In this mode, the radio scans through the channels until a station is found. The radio will stop at the station for five seconds while displaying the channel number, after which scanning will continue until the entire channel has been scanned from the low end to the high end. Also during the category selection, channel scan can be performed in that category. Press the "SCAN" button again to cancel the SCAN mode and to stop on any displayed channel. Selecting preset channels Presetting a channel with a preset button (10) allows you to select that channel in a single operation. Up to six, SAT1, SAT2 and SAT3 channels each may be preset. How to preset channels 1. Press the "SAT" button (1) to select SAT1, SAT2 and SAT3 reception. 2. Press the "SCAN" button (8) or the TUNE TRACK button (4) to select the channel. 3. Press one of the preset buttons (10) for more than 1.5 seconds to store the channel. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory. NOTE If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all channels stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset buttons. Display selection Press the "AUDIO" (5) button while receiving satellite radio to change the display as follows: CHANNEL CATEGORY TITLE NAME Rear seat entertainment If your vehicle is equipped with a Rear Seat Entertainment System, you can enjoy audio outputs from the system through the vehicle's speakers by pressing the "RSE AUX" button (3). Press the button again to return to the audio set sound. - CONTINUED -