2007 Subaru Outback Owner's Manual - Page 144

Instruments and controls 3-21 Cruise control set indicator light The cruise control set indicator light comes on when the ignition switch is turned to the "ON" position and goes out after approximately 3 seconds. This light comes on when vehicle speed has been set. Clock NOTE If your vehicle is equipped with a navigation system, refer to the separate "Operating Instructions for Monitor System". Headlight indicator light This indicator light comes on when the light switch is turned to the " " position (to turn on the parking lights) or to the " " position (to turn on the headlights). 300602 CLOCK Front fog light indicator light This indicator light is on while the front fog lights are on. 300603 Daytime running light indicator light (U.S.) (Canada) The clock shows the time while the ignition switch is in the "ACC" or "ON" position. To adjust the time shown by the clock, press the "+" button or the "-" button. The indicated time will change in one-minute increments. If you keep the button pressed, the rate at which the indicated time changes will speed up. When you keep either the "+" or "- " button pressed, time change will pause for 1 second at the end of each 30-minute change. The clock will start going forward or backward again quickly after this 1-second pause. The daytime running light indicator light comes on when the daytime running light system is operating. Refer to the "Light control switch" section in this chapter. To ensure safety, do not attempt to set the time during driving, as an accident could result.