2007 Subaru Outback Owner's Manual - Page 223

6-20 Interior equipment from the HomeLink® button surface. 3. Press and hold the hand-held transmitter button. The HomeLink® indicator light will flash, first slowly and then rapidly. 4. When the indicator light begins to flash rapidly, release both buttons. The programming for the previous device is now erased and the new device can be operated by pushing the HomeLink® button. In case a problem occurs If you cannot activate a device using the corresponding HomeLink® button after programming, contact HomeLink at www.homelink.com or call 1-800-3553515 for assistance. Rear view camera (if equipped) When the ignition switch is "ON" and the selector lever is set to "R", the rear view camera automatically displays the rear view image from the vehicle. Erasing memory NOTE HomeLink® button Performing this procedure erases the memory of all the preprogrammed buttons simultaneously. The memory of individual buttons cannot be erased. It is recommended that upon the sale of the vehicle, the memory of all programmed HomeLink® buttons be erased for security purposes. 1. Press and hold the two outside buttons until the indicator light begins to flash (after 20 seconds). 2. Release both buttons. Since the rear view camera uses a wide-angle lens, the image on the monitor is different from the actual view in terms of distance. Since the range of the image on the monitor is limited, you should always check the rear view with your eyes and move backward at a slow speed. Do not disassemble or modify the camera, switch or wiring. If smoke comes out or you smell a strange odor, stop using the rear view camera immediately. Contact your Subaru dealer for an inspection. Continued use may result in accident, fire or electric shock.