2012 Subaru Tribeca Owner's Manual - Page 299
2012 Subaru Tribeca Manual
Page 299 highlights
3-10 Instruments and controls : Door open warning light If any lights do not illuminate, it indicates a burned-out bulb or a malfunction of the corresponding system. Consult your authorized SUBARU dealer for repair. the ignition switch is turned to the "ON" position, the seatbelt warning light(s) will flash for 6 seconds, to warn that the seatbelt(s) is/are unfastened. If the driver 's seatbelt is not fastened, a chime will also sound simultaneously. & Seatbelt warning light and chime Your vehicle is equipped with a seatbelt warning device at the driver 's and front passenger 's seat. With the ignition switch turned to the "ON" position, this device reminds the driver and front passenger to fasten their seatbelts by illuminating the warning lights in the locations indicated in the following illustrations and sounding a chime. NOTE . If the driver 's and/or front passenger 's seatbelt(s) is/are still not fastened 6 seconds later, the seatbelt warning device operates as follows according to the vehicle speed. - At speeds lower than approximately 9 mph (15 km/h) The warning light(s) for unfastened seatbelt(s) will alternate between steady illumination and flashing at 15-second intervals. The chime will not sound. - At speeds higher than approximately 9 mph (15 km/h) The warning light(s) for unfastened seatbelt(s) will alternate between flashing and steady illumination at 15-second intervals and the chime will sound while the warning light(s) is/are flashing. . It is possible to cancel the warning operation that follows the 6-second warning after turning ON the ignition switch. When the ignition switch is Driver's warning light Front passenger's warning light ! Operation If the driver and/or front passenger have/ has not yet fastened the seatbelt(s) when