2012 Subaru Tribeca Owner's Manual - Page 366
2012 Subaru Tribeca Manual
Page 366 highlights
Audio 5-19 should have your satellite radio tuner ID ready because each tuner is identified by its unique satellite radio tuner ID. The satellite radio ID will be needed when you activate satellite radio and receive satellite radio customer support. The satellite radio ID can be found on the audio display by tuning the channel to "0". Turn the "TUNE/TRACK" button (4) to select the satellite radio channel. ! Band selection button Push the "SAT" button (1) when the radio is off to turn on the radio. Push the "SAT" button when the radio is on to select SAT1, SAT2 or SAT3 reception. ! Channel selection Press " " of the "TUNE TRACK" button (4) to select the next channel and press " " of the button to select the previous channel. Keep pressing " " of the button to change to the next channel continuously and keep pressing " " of the button to change to the previous channel continuously. ! Category selection Press " " or " " of the "SEEK FLDR" button (7) to display the current category. Press " " again to select the next category, and press " " again to select the previous category. ! Channel scan Press the "SCAN" button (8) to change the radio to the SCAN mode. In this mode, the radio scans through the channels until a station is found. The radio will stop at the station for 5 seconds while displaying the channel number, after which scanning will continue until the entire channel has been scanned from the low end to the high end. Also during the category selection, channel scan can be performed in that category. Press the "SCAN" button again to cancel the SCAN mode and to stop on any displayed channel. ! Selecting preset channels Presetting a channel with a preset button (10) allows you to select that channel in a single operation. Up to six, SAT1, SAT2 and SAT3 channels each may be preset. ! How to preset channels 1. Press the "SAT" button (1) to select SAT1, SAT2 and SAT3 reception. 2. Press the "SCAN" button (8) or the "TUNE TRACK" button (4) to select the channel. 3. Press and hold one of the preset buttons (10) to store the channel. If the button is pressed briefly, the preceding selection will remain in memory. NOTE If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all channels stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset buttons. ! Display selection Press the "AUDIO" button (5) while receiving satellite radio to change the display as follows. ! Rear seat entertainment If your vehicle is equipped with a Rear Seat Entertainment System, you can enjoy audio outputs from the system through the vehicle's speakers by pressing the "RSE AUX" button (3). Press the button again to return to the audio set sound. - CONTINUED -