2012 Subaru Tribeca Owner's Manual - Page 398
2012 Subaru Tribeca Manual
Page 398 highlights
Interior equipment 6-21 opener by pressing the programmed HomeLink® button. & Programming other devices To program other devices such as door locks, home lighting and security systems, contact HomeLink at www.homelink.com or call 1-800-355-3515. 1. Press and hold the two outside buttons until the indicator light begins to flash (after 10 seconds). Rear view camera (if equipped) & Operating the HomeLink® Wireless Control System Once programmed, the HomeLink® Wireless Control System can be used to remote-control the devices to which its buttons are programmed. To activate a device, simply press the appropriate button. The indicator light illuminates, indicating that the signal is being transmitted. 2. Release both buttons. & In case a problem occurs If you cannot activate a device using the corresponding HomeLink® button after programming, contact HomeLink at www.homelink.com or call 1-800-3553515 for assistance. & Erasing HomeLink® button memory NOTE . Performing this procedure erases the memory of all the preprogrammed buttons simultaneously. The memory of individual buttons cannot be erased. . It is recommended that upon the sale of the vehicle, the memory of all programmed HomeLink® buttons be erased for security purposes. A rear view camera is attached to the rear gate. When the ignition switch is "ON" and the select lever is set to "R", the rear view camera automatically displays the rear view image behind the vehicle on the navigation monitor or on the inside mirror. WARNING . Since the rear view camera uses a wide-angle lens, the image on the monitor is different from the actual view in terms of distance. . Since the range of the image on the monitor is limited, you should always check the rear view and - CONTINUED -