3Com 3CR16708-91 Getting Started Guide - Page 45
Setting Up Command Line Interface Management, CLI Management via the Console Port
UPC - 662705487151
View all 3Com 3CR16708-91 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Setting Up Command Line Interface Management 45 Figure 15 SNMP management over the network Refer to "Setting Up SNMP Management" on page 47. Setting Up Command Line Interface Management This section describes how you can set up command line interface management using a local console port connection or over the network. CLI Management via To manage a Switch using the command line interface via the local the Console Port console port connection: 1 Ensure you have connected your workstation to the console port correctly as described in "Connecting to the Console Port" on page 37. 2 Your Switch is now ready to continue being managed and/or configured through the CLI via its console port. CLI Management over To manage a Switch using the command line interface over a network the Network using Telnet: 1 Ensure you have already set up the Switch with IP information as described in "Setting Up Overview" on page 34. 2 Check that you have the IP protocol correctly installed on your management workstation. You can check this by trying to browse the World Wide Web. If you can browse, the IP protocol is installed. 3 Check you can communicate with the Switch by entering a ping command at the DOS prompt in the following format: ping xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx is the IP address of the Switch) If you get an error message, check that your IP information has been entered correctly and the Switch is powered up.