3Com 3CR17561-91-US Getting Started Guide - Page 49
system-view, interface vlan 1, ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm
UPC - 662705496238
View all 3Com 3CR17561-91-US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Manually Configuring IP Information 49 2 At the login and password prompts, enter admin as your user name and press Return and at the password prompt press Return again. If you have logged on correctly, should be displayed as shown in Figure 18. Once you have logged in you will automatically be in User View. Figure 18 User View Login 3 Enter the system-view command and Enter. To confirm that you are in the System View, the following should be displayed: [4500] 4 Enter interface vlan 1 and Enter. 5 Enter the IP address and subnet mask for the Switch as follows: ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm and Enter. (where xxx.xxx.xxx.xxx is the IP address and mmm.mmm.mmm.mmm is the subnet mask of the Switch) 6 Select the quit command and enter the default gateway for the Switch: ip route-static 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx is the IP address of the default gateway) 7 From the User View, enter the save command to save the configuration to your Switch as the configuration is not saved automatically when the Switch is powered down. The initial set up of your Switch is now complete and the Switch is ready for you to set up your chosen management method. See "Methods of Managing a Switch" on page 42.