3Com 3CR17561-91-US Getting Started Guide - Page 53
Viewing Automatically Con d IP Information, Managing a Switch
UPC - 662705496238
View all 3Com 3CR17561-91-US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Viewing Automatically Configured IP Information 53 Figure 20 User View Login via Telnet Viewing Automatically Configured IP Information 4 Enter the system-view command and Enter. 5 Enter interface vlan 1 and Enter. 6 Enter the IP address and subnet mask for the Switch as follows: ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm (where xxx.xxx.xxx.xxx is the IP address and mmm.mmm.mmm.mmm is the subnet mask of the Switch) 7 Enter the default gateway for the Switch: ip route-static 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx is the IP address of the default gateway) 8 From the User View, enter the save command to save the configuration to your Switch as the configuration is not saved automatically when the Switch is powered down. The initial set up of your Switch is now complete and the Switch is ready for you to set up your chosen management method. See "Methods of Managing a Switch" on page 42. If you allow the Switch to automatically configure its own IP information you need to discover and view the IP information before you can begin to manage the Switch. You can discover the IP information in two ways: ■ Using 3Com Network Director - this application will auto-discover the Switch and display the automatically allocated IP information assigned to the Switch.