3Com 3CR17561-91-US Getting Started Guide - Page 51
Using the Web Interface, Network Interface Card NIC in the workstation.
UPC - 662705496238
View all 3Com 3CR17561-91-US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Manually Configuring IP Information 51 Connecting the Workstation to the Switch 1 Connect the workstation to a front panel port using an Ethernet cable as shown in Figure 19. Figure 19 Connecting a Workstation to the Switch via a Front Panel Port Switch Workstation (with a Network Interface Card installed) Ethernet Cable To connect the cable: Front Panel Port Connection a Attach an RJ-45 connector at one end of the Ethernet cable to the Network Interface Card (NIC) in the workstation. b Connect the RJ-45 connector at the other end of the cable to one of the front panel ports on the Switch. Do not interconnect the Switch to any other unconfigured Switch. Setting Up the Switch with IP Information You are now ready to manually set up the Switch with IP information. You can do this using the Web interface or the command line interface (CLI) via telnet. Using the Web Interface 1 Power-up the Switch. This takes approximately one minute. 2 Open a suitable Web browser and enter the IP address of your Switch in the Address field. If there is no response, wait for one minute then re-enter the IP address. If a pop up message appears displaying download and install simplified Chinese information, click Cancel. 3 At the login and password prompts, enter admin as your user name and press Return and at the password prompt (default user name and password) press Return again. If you have logged on correctly, the Device View of the Switch is displayed.