AIWA CX-NA30 Operating Instructions - Page 16

MICROPHONE MIXING VOCAL FADEFUMULTIPLEX FUNCTIONS This unit can use discs orta~es as Karaoke sources. Press the KARAOKE button repeatedly to select the vocal fader or multiplex function. Use the vocal fader function for ordinary discs or tapes. Use the multiplex function for multi audio discs or tapes. Each time the KARAOKE button is pressed, one of these functions is selected cyclically. 'ARA"KE-MII A microphone (not supplied) can be connected to this unit, allowing you to sing along to music sources. Use a microphone with mini plugs (03.5 mm, '/8 inch). 1 Connect your microphone to the MIC jack. MIC 2 Press one of the function buttons to select the source to be mixed, and play the source. 3 Adjust the volume and tone of the source. 4 Turn the MIC VOL control to adjust the microphone volume. To record microphone sound mixed with source sound Follow the procedure for-recording from the sound source (see page 11). The SYNCHRO DUBBING button cannot be used for mixing recording. When not using the microphone Set the microphone volume to MIN and remove the microphones from the MIC jack.' m q If a microphone is held too near the speakers, a howling sound may be produced. In this case, hold the microphone away from the speakers, or decrease the microphone volume. q If sound through the microphone is extremely loud, it may be distorted. In this case, decrease the microphone volume. Recommended microphones The use of unidirectional type microphone is recommended to prevent howling. Contact your local Aiwa dealer for details. @ Vocal Fader The singer's voice becomes softer than the accompaniment. @ Auto Vocal Fader The singer's voice becomes softer only while there is audio input through a microphone. @ Multiplex Only the sound on the left channel is heard from both speakers, and the sound on the right channel is muted. @) Auto Multiplex The sound on the left channel is heard from both speakers, and the sound on the right channel is muted only while there is audio input through a microphone. @ Cancel To change the time lag setting in Auto Vocal Fader or , Auto Multiplex function The muted origfnal singer's voice can be turned faster to the normal level. When Auto Vocal Fader or Auto Multiplex is selected, "A-VF or "AUTO MPX' is displayed for 3 seconds and changes to the selected function name. After the selected function name is displayed; hold down the KARAOKE button until FAST is displayed. To return to the initial settirtg, select SLOW. When the power is turned off, SLOW is restored. To change the audible channel in Multiplex function Only the sound on the right channel can be heard from both speakers. When Multiplex is selected, "MPX L-ch" is displayed for 3 seconds and changes to the selected function name. After the selected function name is displayed, hoId down the KARAOKE button until MPX-R is displayed. .To return to the initial setting, select MPX-L. When the power is turned off, MPX-L is restored. m q The Karaoke functions may not operate correctly with the following kinds of CDs or tapes. - Those with monaural sound - Those recorded with strong echoes - Those with the vocal part recorded on the right or left side of the sound width q While the Karaoke function is on, the sound is output as monaural.