ASRock N100M Software/BIOS Setup Guide - Page 9

Step 5, Step 6

Get ASRock N100M PDF manuals and user guides View all ASRock N100M manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

Intel N100 Series Step 5 A messages pops up saying, "During installation, your system may reboot and continue installing remaining item(s)". Click "Yes" to continue. Click "No" to exit. Step 6 Once all drivers are successfully installed, a message pops up saying, "Installation has been successfully completed! For further drivers and utilities, please visit ASRock's website." Click "Ok" to complete the procedure. When driver installation is completed, the Auto Driver Installer tool will be uninstalled automatically from your computer. After driver installation, the Auto Driver Installer will be removed. If you would like to run the application again, please go to the "Tool" menu in the BIOS setting, and set the "Auto Driver Installer" item to [Enabled]. 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
5
Intel N100 Series
Step 5
A messages pops up saying, "
During installation, your system may reboot and continue
installing remaining item(s)
".
Click "Yes" to continue.
Click “No” to exit.
Step 6
Once all drivers are successfully installed, a message pops up saying, "
Installation has
been successfully completed! For further drivers and utilities, please visit ASRock's
website.
"
Click "Ok" to complete the procedure.
When driver installation is completed, the Auto Driver Installer tool will be uninstalled
automatically from your computer.
Aſter driver installation, the Auto Driver Installer will be removed. If you would like
to run the application again, please go to the “Tool“ menu in the BIOS setting, and
set the “Auto Driver Installer“ item to [Enabled].