Adaptec AAA-UDMA Hardware Guide - Page 18
Installing the AAAUDMA, AAA-UDMA Installation and Hardware Guide
View all Adaptec AAA-UDMA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
AAA-UDMA Installation and Hardware Guide Installing the AAA-UDMA Follow these steps to install the AAA-UDMA: Note: If you are installing the AAA-UDMA in an existing system, back up all data before continuing with installation. 1 Turn OFF power to the computer and disconnect the power cord. 2 Remove the cover from the computer case. 3 Locate an unused, unobstructed, PCI expansion slot and remove the expansion slot cover. (The expansion slot must be PCI 2.1 or higher and must support Bus Mastering.) Save the slot cover screw for use in Step 4. 4 Insert the AAA-UDMA in the PCI expansion slot; press down firmly until it clicks into place, then replace the slot cover screw. AAA-UDMA Installed in PCI Expansion Slot Figure 2-3. Installing an AAA-UDMA in PCI Expansion Slot 2-4