Alpine CDE-HD148BT User Manual - Page 53

Installation Air ventilation hole Hex Nut (M5) Metal Mounting Strap Screw * Bolt Stud Rear of the Unit Caution Do not block the unit's fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire. CAUTION When you install this unit in your car, do not remove the detachable front panel. If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place. The main unit must be mounted within 35 degrees of the horizontal plane, back to front. Detachable Front Panel This unit Note • For the screw marked "*", use an appropriate screw for the chosen mounting location. 3 Slide the CDE-HD148BT/CDE-147BT into the dashboard until it clicks. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the detachable front panel. Removal 1 Remove the detachable front panel. 2 Insert the bracket keys into the unit, along the guides on either side. The unit can now be removed from the mounting sleeve. This unit Bracket keys (Included) Less than 35° 1 Remove the mounting sleeve from the main unit (Refer to "Removal" on page 53). Mounting Sleeve (Included) Dashboard 3 Pull the unit out, keeping it unlocked as you do so. JAPANESE CAR This unit Front Frame Screws (M5 × 8) (Included) Pressure Plates* This unit * If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem. 2 Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot. Connect each input lead coming from an amplifier to the corresponding output lead coming from the left rear of the CDE-HD148BT/CDE-147BT. Connect all other leads of the CDE-HD148BT/CDE-147BT according to details described in the CONNECTIONS section. Mounting Bracket 53-EN