Alpine IVA D310 Owners Manual - Page 75
Installation - iva install
UPC - 793276200433
View all Alpine IVA D310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Installation Installing the Monitor Installation Location Before deciding on the mounting location, check that opening and closing the display will not hamper gear shifting in that position. • Install at an angle of within 30 degrees from the horizontal. • The monitor's angle is set to 90 degrees at the factory. Depending on the car, the monitor may hit the dashboard when opened. The monitor's angle can be adjusted and stored in memory so that the monitor will not hit the dashboard when opening. For adjusting the monitor, refer to "Adjusting the Monitor Viewing Angle" on page 11. Even when the vehicle's battery power is removed, the adjusted monitor angle remains stored in memory. 1 Dashboard Mounting Sleeve (Included) Mounting Bracket (Included) IVA-D310 Flush head Screws (M4 × 3) (Included) Slide the mounting sleeve into the dashboard. Install the supplied bracket on the monitor. • Make sure to use the supplied Flush head screw (M4 × 3) to install the monitor. If you use another screw to install the monitor, it may cause a malfunction. 2 Hex Nut (M5) Screw Bolt Stud Meatal Mounting Strap IVA-D310 Reinforce the monitor unit with a metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw ( ) already attached to the vehicle's chassis. • For the screw marked , use an appropriate screw for the chosen mounting location. Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the IVA-D310. Connect all other leads of the IVAD310 according to details described in the Connections section. 3 Lock Pin Slide the IVA-D310 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the supplied Front Frame. Removal 1. Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see Step 3). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin. 2. Pull the unit out, keeping it unlocked as you do so. < JAPANESE CAR > To install using the vehicle's standard bracket. Ground Lead IVA-D310 Flush Head Screws (M4 × 3) (Included) Mounting Bracket • Make sure to use the supplied flush head screw (M4 × 3) to install the monitor. If you use another screw to install the monitor, it may cause a malfunction. However, only if you cannot install with the flush head screws (M4 × 3), use the supplied screw (M4 × 6). Ground Lead Chassis Front Frame (Included) Wider edge should face down. 73-EN