Alpine IVA D310 Owners Manual - Page 77

Parking Brake Lead Connection If necessary, use a pinch connector to connect the foot brake lead, parking brake lead, etc. 1 Vehicle Cable 2 Pinch Connector Pliers Monitor Cable Stopper Foot Brake Lead / Parking Brake Lead Connection IVA-D310 Tuner Box FOOT BRAKE (Yellow/Black) PARKING BRAKE Pinch Connector (Yellow/Blue) Pinch Connector Foot brake lamp Foot brake lead Parking brake lamp Parking brake lead Foot brake switch Chassis Battery Parking brake switch Connection Diagram of SPST Switch (Sold Separately) (If the ACC power supply is not available) IVA-D310 (Monitor and Tuner Box) IGNITION (Red) BATTERY (Yellow) SPST SW (Optional) FUSE (5A) (Optional) FUSE (20A) (Optional) Battery • If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately). • The diagram and the fuse amperage shown above are in the case when IVA-D310 is used individually. • If the switched power (ignition) lead of the IVA-D310 is connected directly to the positive (+) post of the vehicle's battery, the IVA-D310 draws some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged. To prevent external noise from entering the audio system. • Locate the unit and route the leads at least 10 cm away from the car harness. • Keep the battery power leads as far away from other leads as possible. • Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis. • If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information. • Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. 75-EN