Beko HII64430GT User Manual - Page 10

Beko HII64430GT Manual

Page 10 highlights

g DANGER: Y The product must be connected to the mains • supply only by an authorised and qualified person. Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised A. persons. DANGER: • 1 The power cable must not be clamped, bent or trapped or come into contact with hot parts of the product. A damaged power cable must be replaced by a qualified electrician. Otherwise, there is risk of electric shock, short circuit or fire! The mains supply data must correspond to the data specified on the type label of the product. The rating plate is either seen when the door or the lower cover is opened or it is located at the rear wall of the unit depending on the unit type. Power cable of your product must comply with the values in "Technical specifications" table. Power cable plug must be within easy reach .fter installation (do not route it above the hob). The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be replaced an ASTA approved BS1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover, the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store. • Fitting a different plug As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals on your plug, proceed as follows: • Brown cable = L (Live) • Blue cable = N (Neutral) • Green/yellow cable must be connected to ground (E)= line. With the alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or in the main fuse box. If in doubt contact a qualified electrician. Green and yellow or green • N Blue or bfck Brown:Dr red UKPl g DANGER: Before starting any work on the electrical installation, disconnect the product from the mains supply. There is the risk of electric shock! Plug the power cable into the socket. Instal ing the product If the oven is below: 20 C C E Es C E C C C 15 mm* min. 10/EN

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

g
DANGER:
Y
The
product
must
be
connected
to
the
mains
supply
only
by
an
authorised
and
qualified
person.
Manufacturer
shall
not
be
held
responsible
for
damages
arising
from
procedures
carried
out
by
unauthorised
persons.
A
.
DANGER:
1
The
power
cable
must
not
be
clamped,
bent
or
trapped
or
come
into
contact
with
hot
parts
of
the
product.
A
damaged
power
cable
must
be
replaced
by
a
qualified
electrician.
Otherwise,
there
is
risk
of
electric
shock,
short
circuit
or
fire!
The
mains
supply
data
must
correspond
to
th
e
data
specified
on
the
type
label
of
the
product.
The
rating
plate
is
either
seen
when
the
door
or
the
lower
cover
is
opened
or
it
is
located
at
the
rear
wall
of
the
unit
depending
on
the
unit
type.
Power
cable
of
your
product
must
comply
with
the
values
in
"Technical
specifications"
table.
Power
cable
plug
must
be
within
easy
reach
.fter
installation
(do
not
route
it
above
the
hob).
The
moulded
plug
on
this
appliance
incorporates
a
13
A
fuse.
Should
the
fuse
need
to
be
replaced
an
ASTA
approved
BS1362
fuse
of
the
same
rating
must
be
used.
Do
not
forget
to
refit
the
fuse
cover.
In
the
event
of
losing
the
fuse
cover,
the
plug
must
not
be
used
until
a
replacement
fuse
cover
has
been
fitted.
Colour
of
the
replacement
fuse
cover
must
be
the
same
colour
as
that
visible
on
the
pin
face
of
the
plug.
Fuse
covers
are
available
from
any
good
electrical
store.
Fitting
a
different
plug
As
the
colours
of
the
wires
in
the
mains
lead
of
this
appliance
may
not
correspond
with
the
coloured
markings
identifying
the
terminals
on
your
plug,
proceed
as
follows:
Brown
cable
=
L
(Live)
Blue
cable
=
N
(Neutral)
Green/yellow
cable
must
be
connected
to
ground
(E)=
line.
With
the
alternative
plugs
a
13
A
fuse
must
be
fitted
either
in
the
plug
or
adaptor
or
in
the
main
fuse
box.
If
in
doubt
contact
a
qualified
electrician.
Green
and
yellow
or
green
N
Blue
or
bfck
Brown:Dr
red
UKPl
g
DANGER:
Before
starting
any
work
on
the
electrical
installation,
disconnect
the
product
from
the
mains
supply.
There
is
the
risk
of
electric
shock!
Plug
the
power
cable
into
the
socket.
Instal
ing
the
product
If
the
oven
is
below:
C
C
C
C
C
C
20
E
Es
E
15
mm*
min.
10/EN