Beko HII64430GT User Manual - Page 23

Troubleshooting Product emits metal noises while heating and cooling. • When the metal parts are heated, they may expand and cause noise. >>> This is not a fault. Product does not operate. • The mains fuse is defective or has tripped. >>> Check fuses in the fuse box. Ifnecessary, replace or reset them. • Product is not plugged into the (grounded) socket. >>> Check the plug connection. • If the display does not light up when you switch the hob on again. >>> Disconnect the appliance at the circuit breaker. Wait 20 seconds and then reconnect it. • Overheat protection is active. >>> Allow your hob to cool down. • The cooking pot is not suitable. >>> Check yourpot. symbol appears on the cooking zone display. • You have not placed the pot on the active cooking zone. >>> Check if there is a pot on the cooking zone. • Your pot is not compatible with induction cooking. >>> Check if your cooking pot is compatible with induction hob. • The cooking pot is not centered properly or the bottom surface of the pot is not wide enough for the cooking zone. >>> Choose a pot wide enough and center the pot on the cooking zone properly. • Cooking pot or cooking zone is overheated. >>> Allow them to cool down. Selected cooking zone suddenly turns off during operation. • Cooking time for the selected cooking zone may be over. >>> You may set a new cooking time or finish cooking. • Overheat protection is active. >>> Allow your hob to cool down. • An object may be covering the touch control panel. >>> Remove the object on the panel. The pot does not get warm even if the cooking zone is on. • Your pot is not compatible with induction cooking. >» Check if your cooking pot is compatible with induction hob. • The cooking pot is not centered properly or the bottom surface of the pot is not wide enough for the cooking zone. >>> Choose a pot wide enough and center the pot on the cooking zone properly. Consult the Authorised Service Agent or echnician with licence or the dealer where you have purchased the product if you can not remedy the trouble although you have implemented the instructions in this section. Never attempt to repair a defective product yourself. 23/EN