Brother International EM611 Owner's Manual - English - Page 36

Lining By using a "SYMBOL' or "INTERNATIONAL" daisy wheel with your typewriter, you can draw both vertical and horizontal lines. Before you can use this function you must replace the daisy wheel for one with "SYMBOL" or "INTERNAL IONAL' fonts. Change the keyboard select switch to position II for the "INTERNATIONAL" daisy wheel, arid to position III for the "SYMBOL' daisy wheel. For vertical lines, first clear all the tab stops by pressing the T CLR while holding down the CODE key and then the REPEAT key. Then set tab stops where you want to draw vertical lines. Move the carrier to the first tab stop set by pressing the TAB key. Then hold down the CODE key and press the vertical line key if you are using the "INTERNATIONAL " daisy wheel or the comma key if you are using the "SYMBOL" daisy wheel. The paper will be fed one line and a vertical line will be drawn. Hold down the REPEAT key until the line extends to the desired length. If you have extended the line too far, use the CORRECTION key to erase the excess. Now press the TAB key again. The carrier will move to the next tab stop, and the paper will move back down to the point where the first line began. Hold down the CODE key and press the vertical line key (the comma key if you are using the "SYMBOL' wheel) again, Then hold down the REPEAT key to draw another vertical line. When the vertical line is equal in length to the first line, the typewriter will automatically stop. Repeat for each tab stop to draw all the required vertical lines. Left Margin Tab Tab Tab Tab Right Margin Press the TAB key to move the carrier to the right margin. Then press the TAB key again to return the carrier to the top of the first vertical line. If you do not want to have horizontal lines, hold down the CODE key and press the IND CLR key to return the carrier to the left margin. If you want horizontal lines, continue with the following directions. 32