Brother International HL-1070 Service Manual - Page 185
Alarm Lamp, Swich, Cancel Printing, Wake-up, Form Feed, Error Recover, Select Feeder
![]() |
View all Brother International HL-1070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
CHAPTER 3 CONTROL PANEL Alarm Lamp The Alarm lamp blinks to indicate a printer error status such as "Cover Open" and "Memory Full." If any other error occurs, the printer indicates the error by blinking the Alarm lamp with another lamp or by printing an error report. Note The Ready, Data and Drum lamps are used to indicate printer errors with the Alarm lamp. See "ALARM INDICATIONS AT A GLANCE" in Chapter 6 and take corrective action for the error. Switch This switch will be used as the following purpose depending on the situation. Cancel Printing If you press the switch during printing, the printer immediately stops printing and ejects the paper. Wake-up If the printer is in sleep mode, pressing the switch wakes it up into the ready state. Form Feed If the Data lamp is on, press the switch. The printer prints any data remaining in the printer memory: this operation is called "Form Feed." Error Recover If an error occurs, the printer will recover from some errors automatically. If the error does not clear automatically, press the switch to clear the error and continue printer operation. Select Feeder If the Ready lamp is on, press the switch. You can select Feeder 1 or Feeder 2. 3-3
![](/manual_guide/products/brother-international-hl1070-service-manual-cb9796c/185.png)